EKG Monitor Screen Prototype (10.1" 1920x1200)

25 mm/s · 10 mm/mV

No NIBP · No Resp

Heart rate HR bpm

--

Source ECG II

Alarm 50–120

SpO₂ %

Ref. value · not calibrated

--

Pulse PR

bpm

--

12-lead · option C1~C6 module · 25 mm/s · 10 mm/mV HR -- SpO₂ --% (reference value) Synthetic signal demo

● Holter recording

Start

Recording time

Channels ECG I · II · III · V1 + SpO₂ · pulse wave

ECG 500 Hz · 24-bit

Used by this recording (at 518.4 MB per day)

Cloud

Trend recording every 1 s · HR · SpO₂ · PR

Event log

Active alarms

Alarm log (last 5)

Alarm limits (HR·PR in steps of 5, SpO₂ 1)

High	red · 1 s blink · 10 beeps
Med	yellow · 1 s blink · 3 beeps
Low	cyan · no blink · 1 beep

Chest electrode switch now: V1

① Clean and dry the skin at each site

② Attach electrodes at the marked sites

③ Match the wire-end letters (RA·LA·LL·RL·V)

④ Set the side V1/V5 switch to the used site

⑤ Check "Chest V1/V5" in the top bar

Waveform

Sweep speed (mm/s)

ECG gain (mm/mV)

60 Hz notch (dual adaptive)

Display · Sound

Brightness (at night: keep the background light, lower only brightness)

Device

Option modules

Alarm sound

Version 0.1.0 · update USB · OTA

Electrode wire colors

Battery health A 98% · B 97% demo values

Wi-Fi Online

Screen refresh -- fps

Demo controls — This tab exists only in the screen prototype. It is not on the actual device.

Patient state

Sensors · electrodes

Power · communication

Alarms turn on only if the condition persists (asystole no R 3 s + 2 s · HR 5 s · SpO₂ 8 s · electrode 2 s). Physiological alarms remain even after the condition recovers, until "Clear past alarms".